The truth about programming


Comments

Post a Comment

Popular posts from this blog

Reading and Writing Operation of SRAM

Image
The diagram below is illustrate Static Random Access Memory (SRAM)Cell for the explanation. SRAM cell is make up of 2 inverters are cross-connected to form a latch .The latch is connected to 2 bit line by transistor T1 and T2 . T1 and T2 can switch opened or closed under control of word line.When word line is ground level, the transistors are turned off and the latch retrains its state. During the Read Operation ,Word line is activated to close switches T1 and T2 . If the cell is in state 1; the signal on b line is high and the signal on b’ line is low.The opposite is true if the cell is in state 0.Thus, b and b’ are always complements of each other’s. The sense /write circuit at the end of the two bit line monitors their state and sets the corresponding output accordingly. While in Write Operation ,the Sense/Write circuit drives bit lines b and b’, instead of sensing their state.It places the appropriate value on bit line b and its complement on b’ and activate the word ...
Read more

Network / Socket Programming In LINUX

Image
Network programming also known as Socket programming. Socket is mechanism used in LINUX for one process communicate with another process that is far and through network. There are 2 type of socket which is TCP socket and UDP socket. What is Socket ? It is a group of system calls for networking capability which are socket() , bind() , listen() , accept() , connect() , close() and others. Socket are one of the Inter-process communication (IPC) facility for communication between one process with another. It provides communication between process on CLIENT machine and SERVER on another machines. The 2 most prevalent communication API (Application Program Interface) for UNIX system are Berkely Sockets and System V TLI(Transport Later Interfaces) . Socket are a protocol independent method of creating a connection between process Socket can be either connection based or connection less , packet based or streams based and reliable or unreliable . Socket are characterized by ...
Read more

Reading & Writing Operation of DRAM

Image
In Dynamic Random Access Memory CELL , transistor acts as a switch to Close (allowing current to flow) when voltage applied in address line or Open (no current flow) when no voltage applied in address line.Address Line also known as word line .Which use to signal the transistor to close or open. During the Write operation ,a voltage is applied on the bit line and a signal applied to the address line to close the transistor.Then the voltage applied on the bit line will transfer to capacitor and store in the capacitor However the capacitor has tendency to discharge and has to refresh to maintain the bit. While in Reading Operation ,the instruction find the bit store using the address line to read the data or bit. When the address line is selected ,the transistor turns on and the charge stored on the capacitor is fled out onto a bit line and to sense amplifier. Sense amplifiers compare the capacitor voltage to reference value to determine the logic 1 or logic 0.The read out from ...
Read more